Sound lag is always manufactured while laminating convoluted acoustic foam, a noise barrier, and a foil facing. This creates an easily installed acoustic treatment for pipes.
Noise sources wasted water travelling through pipes impacts around corners and bends. So, while installing the pipes is not such a lengthy process, we can walk you through it step by step.
- So, the first step would be to measure the pipe diameter properly. Next, you lay out the sound lag roll and then cut the sound lag to size measuring the circumference of the pipe, allowing for overlap and some fine thickness.
- So as to make sure that there's a tight seal a 20-30ml of foam can be stripped away to provide a visible overlap. The legging can also be overlapped without foam removal.
- One just needs to make sure that each segment overlaps to ensure noise does not escape the wrap. To do this you need to wrap around the pipe, overlap the link as a tight seal is critical for maximum performance.
- Seal all joints with an ALR tape and rub it down to ensure that the adhesive in the tape activates creating a life-long bond.
- Overlapping the pipe is most important as buck joining can result in a decrease in performance.
- Sound lag material is very easy to cut allowing fitting around 45- and 90-degree bends. Position the material for overlaps and tape all joints to ensure there's a good right seal.
You can learn much more about this on the internet from places like glass wool insulation sheets.